1. | Remove seat. | |
WARNING To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) | ||
2. | Disconnect and remove battery negative (-) cable (black) from battery negative (-) terminal. | |
3. | Pull cover away from fuse block. | |
NOTICE Always use replacement fuses that are of the correct type and amperage rating. Use of incorrect fuses can result in damage to electrical systems. (00222a) | ||
4. | See Figure 1. Replace suspect fuse. |
1. | Place cover over fuse block. | |
2. | Install battery negative cable (black) to battery negative (-) terminal. | |
3. | Tighten fastener to 6.8–10.8 N·m (60–96 in-lbs). | |
WARNING After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
4. | Install seat. |
1 | Instruments fuse |
2 | Ignition fuse |
3 | Lights fuse |
4 | P&A (2 Amp max) |
5 | Battery fuse |
6 | Accessories fuse |
7 | ECM fuse |
8 | Engine control fuse |
9 | Headlamp fuse |
10 | Spare 15 Amp |
11 | Spare 15 Amp |
12 | Fuel pump fuse |
13 | System Relay |
14 | Starter Relay |