Bulb Replacement
NOTE
Figure 1 shows tail lamp for FLSTC and FLSTF models. Tail lamps on FXST, FXSTC and FXSTB are similar, but are oriented 180° differently.
  1. See Figure 1. Remove two screws and lens from base.
  2. Depress locking tab and remove 4-pin multilock connector from circuit board.
  3. Rotate bulb socket 1/4 turn in a counterclockwise direction and remove from tail lamp assembly. Gently pull bulb from socket.
  4. Coat base of new bulb with ELECTRICAL CONTACT GREASE (Part No. 99861-90). Install new bulb in socket.
  5. Insert socket into tail lamp assembly and rotate 1/4 turn in a clockwise direction. Connect 4-pin multilock connector to circuit board.
  6. Install lens to base with two screws. Tighten screws to 20-24 in-lbs (2.3-2.7 Nm).
1Lens
2Base
34-pin multilock connector
4Bulb assembly
Figure 1. Tail Lamp Assembly: FLSTC/FLSTF