NOTICE
Oil level cannot be accurately measured on a cold engine. For pre-ride inspection, with motorcycle leaning on jiffy stand on level ground, oil should register on dipstick between arrows when engine is cold. Do not add oil to bring the level to the FULL mark on a COLD engine. (00185a)
For dipstick location, see Figure 1.
NOTE
The motorcycle should be on jiffy stand when checking oil level.
Oil Level Cold Check
Perform engine oil level COLD CHECK as follows:
  1. For preride inspection with the vehicle on jiffy stand on level ground, wipe off the dipstick and insert it back into the oil tank with the plug pushed completely into the fill spout.
  2. Remove the dipstick and verify oil registers on the dipstick between the two marks.
    1. See Figure 2. If oil level registers on the dipstick, proceed to Oil Level Hot Check.
    2. If oil does not register on the dipstick, proceed to step 3.
  3. With the dipstick removed, look into the dipstick opening and verify the oil level is at the filler neck weld.
    1. If the oil level is at or near the filler neck weld, proceed to Oil Level Hot Check.
    2. If the oil level is not at or near the filler neck weld, add only enough oil to bring the level to the filler neck weld. Then proceed to Oil Level Hot Check.
Oil Level Hot Check
Perform engine oil level HOT CHECK as follows:
  1. Ride motorcycle until engine is at normal operating temperature.
  2. With the vehicle upright on level ground, allow engine to idle for 1-2 minutes. Turn engine off.
  3. With vehicle on jiffy stand remove and wipe off the dipstick. Insert dipstick back into the oil tank with the plug pushed completely into the filler neck.
  4. Remove the dipstick and note the level of the oil. Add only enough oil to bring the level to the FULL mark on the dipstick. Do not overfill.
  5. Start engine and carefully check for oil leaks around drain plug and oil filter.
Engine oil level should be checked only when engine is at normal operating temperature.
NOTE
The engine will require a longer warm up period in colder weather.
NOTICE
Do not allow hot oil level to fall below Add/Fill mark on dipstick. Doing so can result in equipment damage and/or equipment malfunction. (00189a)
NOTICE
Do not overfill oil. Doing so can result in oil carryover to the air cleaner leading to equipment damage and/or equipment malfunction. (00190b)
1Filler neck
2Dipstick
Figure 1. Checking Oil Tank Level: Softail Models
1Full mark
2Fill mark
Figure 2. Engine Oil Level: Softail Models