Removal
  1. Remove two screws to release tail lamp assembly from chrome base.
  2. See Figure 1. Disconnect tail lamp connector (3).
  3. Rotate bulb socket (4) a quarter turn counterclockwise and remove from tail lamp assembly. Remove bulb.
Installation
1. Coat base of new bulb with ELECTRICAL CONTACT LUBRICANT. Install new bulb.
2. See Figure 1. Insert socket (4) into tail lamp assembly. Rotate a quarter turn clockwise.
3. Attach tail lamp connector (3).
4. Place tail lamp into position against chrome base.
NOTE
Do not over-tighten screws.
5. Install two screws. Tighten to 2.3–2.7 N·m (20–24 in-lbs).
WARNING
Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
6. Check operation of all lamps.
1Bulb socket
2Tail lamp connector
3Base
4Lens
Figure 1. Incandescent Tail Lamp Assembly