CAUTION
Do NOT pull on any electrical wires. Pulling on electrical wires may damage the internal conductor causing high resistance, which may result in minor or moderate injury. (00168a)
WARNING
Do not exceed Tour-Pak weight capacity. Too much weight can cause loss of control, which could result in death or serious injury. (00401c)
NOTE
Maximum luggage rack weight capacity is 4.5 kg (10 lb). Combined load of luggage rack and Tour-Pak must not exceed 13.6 kg (30 lb).
Lock/Unlock with key fob: See Controls and Indicators → POWER LOCKS → Key Fob. Press the LOCK or UNLOCK button on the key fob.
Lock/Unlock with power lock switches: See Controls and Indicators → POWER LOCKS → Power Lock Switches. With motorcycle turned on, press the lock or unlock switch in the fairing cap panel.
Lock/Unlock with key: See Figure 1. To lock, insert key and rotate one-quarter turn clockwise. To unlock, rotate key one-quarter turn counterclockwise.
Open: Pull the latch handle. Raise the lid.
Close: Close the lid. Push the latch handle to secure the lid. Lift on lid to check that it is secure.
Tie down and secure any cargo installed on the luggage rack before riding.
1Latch handle
2Unlock (toward rear of vehicle)
3Lock (toward front of vehicle)
Figure 1. Tour-Pak
Adjustment
The position of the Tour-Pak can be adjusted forward or rearward for passenger comfort.
NOTE
The Tour-Pak position cannot be adjusted on Asia Pacific (APC) configuration motorcycles, except to access the seat screw. To determine vehicle configuration, check the VIN identifier in Identification → Vehicle Identification Number (VIN) → Harley-Davidson VIN Breakdown: 2017 FLHTKSE. See SEAT ACCESS (APC MODELS) to move the Tour-Pak on APC configuration vehicles.
1. See Figure 2. Loosen the four nuts securing the Tour-Pak to the support.
2. Slide the Tour-Pak to the desired position.
3. Tighten the four nuts to 6.8–8.1 N·m (60–72 in-lbs).
Figure 2. Tour-Pak Position Adjustment
Seat Access: Asia Pacific (APC) Models
On APC vehicles, the Tour-Pak can be moved rearward to access the seat screw. To determine vehicle configuration, check the VIN identifier in Identification → Vehicle Identification Number (VIN) → Harley-Davidson VIN Breakdown: 2017 FLHTKSE. The Tour-Pak must be installed in its original position before riding.
1. See Figure 3. Remove the four screws securing the Tour-Pak bracket to the support.
2. Pull the Tour-Pak rearward to access the seat screw.
3. When finished, move the Tour-Pak to its original position. Align all four holes in the bracket with the slots in the support.
4. Install the four screws. Tighten to 6.8–8.1 N·m (60–72 in-lbs).
Figure 3. Tour-Pak Bracket Screws (APC Models)