See Figure 1. The engine OFF/RUN switch turns the engine power ON or OFF. The switch is in the right hand controls.

OFF: Press the top of the OFF/RUN switch to turn off the engine. After shutting off the engine, turn the ignition switch OFF to completely turn off the motorcycle.

RUN: Press the bottom of the OFF/RUN switch to turn on ignition power before starting the motorcycle.

See Figure 1. The engine start/hazard warning switch is in the right hand controls.

START: Pressing the bottom of the switch operates the starter motor. See Operation → Starting the Engine.

Hazard Warning: Pressing the top of the switch (triangle symbol) operates the four-way flashers. This system allows a stranded motorcycle to be left in the four-way flashing mode and secured until help is found.

See Figure 1. The horn is operated by pressing the HORN switch in the left hand controls. The horn can be activated for up to 10 seconds at a time. If the HORN switch is held for a longer period, the horn will automatically deactivate.

See Figure 1. The headlamp dimmer switch is in the left hand controls. The switch has three positions.

High beam: Press the top of the switch to activate the high beam. The high beam indicator shows when the high beam is turned on.

Low beam: Press the lower portion of the switch to activate the low beam.

Stealth mode: Press and hold the bottom of the switch to activate stealth mode. When in stealth mode, all vehicle lamps are deactivated except for the instrument lamps and brake lamp. Press the bottom of the switch or the emergency lamp switch to deactivate stealth mode.

See Figure 1. The turn signal switches are in the left and right hand controls.

Activating: Press and release the left or right turn signal switch to activate the turn signal lamps. The lamps flash until they are automatically canceled or manually canceled by the rider.

Automatic canceling: The turn signal lamps automatically cancel when a full turn has been detected. The lamps also cancel if the turn signal has been activated for a prolonged period while riding. The lamps will not cancel while the motorcycle remains stopped or at a very low speed.

Manual canceling: To cancel the turn signal, press and release the turn signal switch a second time. To activate the opposite turn signal, press and release the turn signal switch for the new direction. The first turn signal cancels and the opposite turn signal lamps begin flashing.

See Figure 1. The CRUISE/SET/RESUME switch automatically regulates the speed of the vehicle. See Controls and Indicators → Cruise Control for detailed operation.

CRUISE: Press the CRUISE switch straight in to enable cruise control. The cruise control indicator lights orange. Pressing the CRUISE switch again turns off cruise control.

SET/-: With cruise control enabled, press SET/- to set the cruising speed. The cruise control indicator lights green. While at cruising speed, press SET/- to decrease the regulated speed.

RESUME/+: If cruise control is disengaged (such as a braking event), press RESUME/+ to resume the previous cruising speed. While at cruising speed, press RESUME/+ to increase speed.

See Figure 1. The voice command switch activates the rider communication device on equipped vehicles.

See Figure 1. The trigger switch is on the front of the left hand controls.

Vehicle off: Press the trigger switch to display the accumulated mileage in the odometer. Press and hold the trigger switch to activate accessory mode, allowing for operation of the emergency lamps for up to 30 minutes.

Vehicle in accessory/ignition mode: Press the trigger switch to cycle through the odometer functions. See Controls and Indicators → Odometer Functions.

See Figure 1. The front brake lever is on the right handlebar and is operated with the fingers of the right hand. Squeeze the brake lever to actuate the front brakes. See Controls and Indicators → Brake System.

See Figure 1. The throttle control grip is on the right handlebar and is operated with the right hand.

Decelerate: Slowly turn throttle control grip clockwise (toward front of motorcycle) to close the throttle.

Accelerate: Slowly turn throttle control grip counterclockwise (toward rear of motorcycle) to open the throttle.

Roll-off position: The throttle control grip can be turned clockwise slightly past the idle position. Turning to the roll-off position disengages cruising speed. The roll-off position is also used when enabling/disabling EITMS. See Operation → Engine Idle Temperature Management System.

See Figure 1. The clutch hand lever is on the left handlebar and is operated with the fingers of the left hand.

The vehicle can be started in any gear as long as the clutch lever is pulled in. If the clutch is not disengaged, the vehicle will not start when in gear.

See Figure 1. The left handlebar contains the siren switch. Press the switch to alternate between on and off.

SIREN OFF: Press the right side of the switch to pulse the siren in YELP mode.

SIREN ON: Press the left side of the switch to activate the siren in WAIL mode. Press the right side of the switch to activate the siren in YELP mode.

See Figure 1. The emergency lamp switch is on the right handlebar.

Press the switch to activate both front and rear emergency lamps. The indicator lamp alternates between green and orange to indicate that the emergency lamps are activated.

Press the switch to the left to activate the front emergency lamps. The indicator lamp with illuminate green to indicate that the front emergency lamps are activated.

Press the switch to the right to activate the rear emergency lamps. The indicator lamp with illuminate orange to indicate that the rear emergency lamps are activated.

Emergency lamps continue to operate when the ignition is switched OFF. To shut down the motorcycle completely turn off the emergency lamps and cycle the ignition ON and then OFF.