Speedometer

WARNING

Travel at speeds appropriate for road and conditions and never travel faster than posted speed limit. Excessive speed can cause loss of vehicle control, which could result in death or serious injury. (00008a)

See Figure 1 and Figure 2. The speedometer registers miles per hour (U.S. models) or kilometers per hour (international models) of forward speed.

The speedometer includes a single display window for the odometer, two trip-odometers, and tip indicator.

Press the function button to change the display window on the speedometer face to either odometer or trip-odometer.

Odometer

See Figure 1 and Figure 2. The odometer registers the number of miles/kilometers the vehicle has traveled. The odometer can display mileage when the motorcycle is on or off by pressing the function button. There is no need to turn the motorcycle on to check the odometer reading.

Trip Odometers

Use trip-odometer A or trip-odometer B to register number of miles/kilometers traveled on a trip or between refueling. The ignition/headlamp key switch must be in the IGNITION or ACCESSORY position to view or reset the trip-odometers.

See Figure 1 and Figure 2. To view the trip-odometer, press the function button until an A or B is displayed in the upper left corner of the odometer window.

To reset a trip-odometer to zero, press the function button to select the trip-odometer to be reset. Press and hold the function button for approximately 2-3 seconds until the trip-odometer resets to zero.

NOTICE

Never attempt to tamper with or alter the vehicle odometer. This is illegal. Tampering with or altering a vehicle odometer may cause equipment damage. (00160a)

Tachometer

NOTICE

See OPERATING RECOMMENDATIONS section. Do not operate the engine above maximum safe RPM as shown under OPERATION (red zone on tachometer). Lower the RPM by upshifting to a higher gear or reducing the amount of throttle. Failure to lower RPM may cause equipment damage. (00159a)

See Figure 1 and Figure 2. The tachometer measures engine speed in revolutions per minute (RPM).

Tip Indicator

WARNING

If tip occurs, check all controls for proper operation. Restricted control movement can adversely affect the performance of the brakes, clutch or ability to shift, which could result in loss of vehicle control and death or serious injury. (00350a)

Should motorcycle be tipped over, the word "tip" will appear in the odometer window. Engine will not start until reset. To reset, cycle ignition/headlamp key switch ON-OFF-ON.

Fuel Gauge

The fuel gauge indicates the approximate amount of fuel in the fuel tank(s) and is located to left of the speedometer or on the left front panel of the fairing.

NOTE

The FLHP left side fuel cap is a fuel gauge only. Do not remove.

Voltmeter (FLHTP)

The voltmeter indicates electrical system voltage and is found on the front panel of the fairing. With the engine running above 1500 RPM, the voltmeter should register 13-14.5 volts with battery at full charge.

Fuel Range Function

The fuel range function shows the approximate mileage available with the amount of fuel left in the fuel tank.

With the ignition switch in the ACC or IGNITION position, press function switch until fuel range function is displayed, as indicated by the letter 'r' in the left side of the odometer display. The calculated remaining distance (miles or kilometers) to empty is displayed, based on the amount of fuel in tank. Range can be accessed at any time using the function switch.
When the low fuel warning lamp illuminates, the range feature will automatically be displayed in the odometer unless this automatic pop-up feature is disabled by a press and hold of the function switch while in range display mode. Automatic range pop-up feature will show that it is disabled by blinking twice. Likewise, automatic range popup can be reactivated by a press and hold of the function switch. Range will blink once when the automatic pop-up feature is re-enabled.

NOTE

When the low fuel warning lamp turns on, there is approximately 3.79 L (1.00 USgal) of fuel remaining in the tank. Refuel as soon as possible.
The range display is only updated when the vehicle is moving.

After the range calculation reaches 16 km (10 mi) remaining, the range display will display "r Lo" to indicate that the vehicle will shortly run out of fuel.
Resetting the low fuel warning lamp and range requires an ignition cycle change.

1	Ignition/headlamp key switch
2	Function switch
3	Fuel gauge
4	Sixth gear lamp
5	Speedometer
6	Check engine lamp
7	Low fuel lamp
8	Battery discharge lamp
9	Fuel filler cap
10	Odometer/trip-odometer
11	Cruise lamp (not used)
12	Security system lamp
13	Tachometer
14	Pursuit lamp
15	ABS lamp (optional)

Figure 1. Instruments: FLHP

1	Fuel gauge
2	Function switch
3	Sixth gear lamp
4	Check engine lamp
5	Low fuel lamp
6	Speedometer
7	Tachometer
8	Voltage gauge
9	Microphone input jack
10	ABS lamp (optional)
11	Pursuit lamp
12	Security system lamp
13	Battery discharge lamp
14	Odometer/trip-odometer

Figure 2. Instruments: FLHTP