1. | Place the ignition/headlamp key switch in the OFF position. | |
2. | Remove left saddlebag and side cover. | |
3. | See Figure 1. Press latch on bottom of fuse block cover and swing bottom of the cover out. Remove the cover. NOTE The fuse block cover has a fuse puller attachment that may be used to remove fuses. | |
4. | See Figure 2 and refer to Table 1. Remove fuse and inspect the element. | |
NOTICE Always use replacement fuses that are of the correct type and amperage rating. Use of incorrect fuses can result in damage to electrical systems. (00222a) | ||
5. | Replace the fuse if the element is burned or broken. NOTE Automotive type ATO fuses are used for replacements. Two spare fuses can be found in the fuse block. | |
6. | Insert the top of the fuse block cover in upper retainer and press bottom of cover to snap into place. | |
7. | Install left side cover and saddlebag. |
1 | Fuse block cover |
2 | Maxi-fuse |
3 | Fuse puller |
ITEM | FUSE | ITEM | FUSE | ITEM | FUSE | ITEM | FUSE |
---|---|---|---|---|---|---|---|
1 | Brake (15 amp) | 2 | Accessory (15 amp) | 3 | P&A (15 amp) | 4 | Radio/siren (15 amp) |
5 | Radio memory (15 amp) | 6 | Battery (15 amp) | 7 | ECM power (15 amp) | 8 | Fuel pump (15 amp) |
9 | System relay | 10 | Start relay | 11 | P&A ignition (2A max) | 12 | Instruments (15 amp) |
13 | Ignition (15 amp) | 14 | Engine control (15 amp) | 15 | Brake relay | 16 | Headlamp (15 amp) |
17 | Lights (15 amp) | 18 | Spare (15 amp) | 19 | ABS (30 amp) | 20 | Spare (30 amp) |