General
WARNING
Improper loading of cargo or installation of accessories can affect motorcycle stability and handling, which could result in death or serious injury. (00099a)
Take notice of the following precautions when using your saddlebags.
NOTE
See Figure 1. All police models feature quick release fasteners to allow rapid saddlebag removal and installation.
Opening and Closing
To open the saddlebag, rotate the knob on the top of the lid in a counterclockwise direction and lift. Lid will open outwards.
To close the saddlebag, close the lid and rotate the knob counterclockwise until it stops.
Removal
  1. Open saddlebag.
  2. See Figure 1. Grasp bail wire inside saddlebag and rotate each stud a full 1/4 turn counterclockwise.
  3. Remove bail head studs with flat washers.
  4. Remove saddlebag.
1Rear mounting bracket
2Front mounting bracket
3Wire form
4Spring plate
5Flat washer
6Bail wire
7Quick-release stud
Figure 1. Quick-Release Fasteners: Police Models
Installation
  1. See Figure 1. Position saddlebag on vehicle. Verify that molded rubber insert on saddlebag fits snugly on lower saddlebag support rail. If saddlebag is not fully seated, loosen bolts securing mounting brackets to saddlebag support and frame.
  2. Install bail head studs.
    1. Place flat washers on bail head studs.
    2. With groove at end of stud held in a horizontal position, insert stud through holes in saddlebag and front mounting bracket.
    3. When groove engages wire form of spring plate on inboard side of bracket, turn stud clockwise a full 1/4 turn until it snaps into place.
    4. Install remaining bail head stud in the same manner.
  3. If loosed previously, tighten bolts securing mounting brackets to saddlebag support and frame.
  4. Close saddlebag.