1. | Place the ignition/headlamp key switch in the OFF position. NOTE Removal of side cover requires no tools. Pull side cover to remove. To install, align barbed studs on side cover with grommets in frame and push. | |
2. | Remove left side cover. | |
3. | Press latch on bottom of fuse block cover (1) and swing bottom of the cover out. Remove the cover. NOTE The fuse block cover has a fuse puller (3) attachment that may be used to remove fuses. | |
4. | See Figure 2. Remove fuse and inspect the element. | |
NOTICE Always use replacement fuses that are of the correct type and amperage rating. Use of incorrect fuses can result in damage to electrical systems. (00222a) | ||
5. | Replace the fuse if the element is burned or damaged. NOTE Use automotive-type fuses for replacements. Two spare fuses can be found in the fuse block. | |
6. | Install the fuse block cover. | |
7. | Install left side cover. |
1 | Fuse block cover |
2 | Main fuse |
3 | Fuse puller |
1 | Brake (15 A) |
2 | Accessory (15 A) |
3 | P&A (15 A) |
4 | Radio power (15 A) |
5 | Radio memory (15 A) |
6 | Battery (15 A) |
7 | ECM power (15 A) |
8 | Fuel pump (15 A) |
9 | System relay |
10 | Start relay |
11 | P&A ignition (2 A max) |
12 | Instruments (15 A) |
13 | Ignition (15 A) |
14 | Lighting relay |
15 | Brake relay |
16 | Headlamp (15 A) |
17 | Lights (15 A) |
18 | Spare (15 A) |
19 | ABS (30 A) |
20 | Audio amplifier (30 A) |
21 | Spare (30 A) |
22 | Main fuse (40 A) |