Removal
  1. See Figure 1. Disconnect the GPS system power connector on the left side of the steering head.
  2. Install rubber plug on motorcycle wire harness.
  3. See Figure 2. Move the TOP of the windshield assembly forward, until the TOP bracket notches slide away from the grommets.
  4. Carefully lift the windshield bracket BOTTOM notches off the bottom grommets.
Installation
  1. See Figure 2. Slide the BOTTOM windshield bracket notches onto the bottom grommets.
  2. Slide the TOP bracket notches onto the top grommets.
  3. Route GPS system power wire over upper fork bracket.
  4. See Figure 1. Remove rubber boot from connector.
  5. Attach GPS connector.
NOTE
For proper windshield maintenance, see Care and Cleaning → Windshield Care.
1GPS system power connector
2Plug
Figure 1. GPS System Power Connector
1Upper grommet
2Lower grommet
3GPS system power connector
Figure 2. Windshield