Do not attempt to enter route information or adjust this device while driving. Failure to pay full attention while riding could result in death or serious injury. (00614b)
See Figure 1. The Road Tech™ zumo® 660 GPS unit provides maps and audio instructions for navigating while riding. The unit is loaded with destinations for Harley-Davidson facilities dealers, and other points of interest. It can be personalized with a home location and favorite destinations.
Routes, maps and trip logs can be shared with others by connecting the unit to a computer. A microSD card can also be used. Ride plans can also be created, shared and downloaded to the GPS unit from the Ride Planner on www.harley-davidson.com.
See the on-screen help and the Road Tech zumo 660 owner's manual to set up and operate the GPS unit.
NOTE
Traffic features are not active on the GPS unit. Traffic receivers and subscription services can be purchased for the GPS unit from Garmin International, Inc.
Maps are preinstalled on the GPS unit. The City Navigator® NT software which comes with the GPS unit can be installed on a computer. It can be used to plan trips and to load trip information into the GPS unit.
Installation
NOTE
Install the battery before using the GPS unit for the first time. See the Road Tech zumo 660 owner's manual for battery installation.
The suction cup mount and power cable provided with the system is intended for use in automobiles only. See the Road Tech zumo 660 owner's manual for proper operation in an automobile.
See Figure 1. Remove the weather cap from the cradle.
Insert the bottom of the GPS unit into the cradle.
Snap the upper end of the GPS unit into place.
Removal
Remove the GPS unit when the motorcycle is not in use to prevent theft or damage.
See Figure 1. Press the release button on the side of the cradle.
Remove the GPS unit from the cradle.
Snap the weather cap onto the cradle mount.
Store the unit in a secure location.
1
Cradle
2
Release button
3
GPS unit
4
Weather cap
Figure 1. Road Tech zumo 660 GPS Unit
Turning the GPS Unit On/Off
Push the OFF/RUN switch to RUN (to turn on the ignition) or push and hold the TRIP switch (to enter accessory mode). The GPS unit automatically turns on and begins charging using motorcycle power.
Turning off the motorcycle ignition or exiting accessory mode will cause the GPS unit to turn off after a 30 second delay.
The GPS unit can also be run on its own battery power. Press the power button on the top of the GPS unit.