Speedometer
WARNINGTravel at speeds appropriate for road and conditions and never travel faster than posted speed limit. Excessive speed can cause loss of vehicle control, which could result in death or serious injury. (00008a)
See Figure 1. The speedometer (1) registers miles per hour (MPH) or, on International models, kilometers per hour (KPH).
The speedometer includes a single display window for the odometer, two trip-odometers, and a trip indicator.
Press the function button (7) to change the display window on the speedometer face to either odometer or trip-odometer.
Odometer
See Controls and Indicators → Warning Lamps → Warning Lamps. The odometer (7) registers the number of miles/kilometers the vehicle has traveled. Odometer will display mileage when motorcycle is OFF when function button is pressed. There is no need to turn the motorcycle on to check the odometer reading.
Trip Odometer
Use the trip-odometer A (7) or trip-odometer B to register number of miles/kilometers traveled on a trip or between refueling.
See Controls and Indicators → Warning Lamps → Warning Lamps. To reset the trip-odometer to zero, press button to reset speedometer display to the ODOMETER mode and hold the button in for approximately 2-3 seconds. The speedometer will switch to the trip-odometer mode and reset the display to zero.
NOTICE
Never attempt to tamper with or alter the vehicle odometer. This is illegal. Tampering with or altering a vehicle odometer may cause equipment damage. (00160a)
Tip Indicator
WARNINGIf tip occurs, check all controls for proper operation. Restricted control movement can adversely affect the performance of the brakes, clutch or ability to shift, which could result in loss of vehicle control and death or serious injury. (00350a)
Should motorcycle be tipped over, the word "tip" will appear in the odometer window. Engine will not start until reset. To reset, cycle ignition/headlamp key switch ON-OFF-ON.
Tachometer
NOTICE
See OPERATING RECOMMENDATIONS section. Do not operate the engine above maximum safe RPM as shown under OPERATION (red zone on tachometer). Lower the RPM by upshifting to a higher gear or reducing the amount of throttle. Failure to lower RPM may cause equipment damage. (00159a)
See Figure 1. The tachometer (2) measures the engine speed in revolutions per minute (RPM).
Voltmeter
See Figure 1. The voltmeter (3) indicates electrical system voltage and is found on the front panel of the fairing. With the engine running above 1500 RPM, the voltmeter should register 13-14.5 volts with battery at full charge.
Oil Pressure Gauge
See Figure 1. The oil pressure gauge (4) indicates engine oil pressure and is found on the front panel of the fairing. Engine oil pressure will normally vary from 34 kPa (5 psi) at idle speed to 207–262 kPa (30–38 psi) at 2000 RPM when engine is at normal operating temperature of 110 °C (230 °F).
Air Temperature Gauge
See Figure 1. The air temperature gauge (5) indicates the ambient air temperature in degrees Fahrenheit. This gauge is found on the front panel of the fairing.
Fuel Gauge
See Figure 1. The fuel gauge (6) indicates the approximate amount of fuel in the fuel tanks.
Clock (In Radio)
The clock runs continuously as long as there is battery power. To reset clock, refer to ADVANCED AUDIO SYSTEM → Advanced Audio System: FLTRSE3.
Fuel Range Function
The fuel range function shows the approximate mileage available with the amount of fuel left in the fuel tank.
- With the ignition switch in the ACC or IGNITION position, press function switch until fuel range function is displayed, as indicated by the letter 'r' in the left side of the odometer display. The calculated remaining distance (miles or kilometers) to empty is displayed, based on the amount of fuel in tank. Range can be accessed at any time using the function switch.
- When the low fuel warning lamp illuminates, the range feature will automatically be displayed in the odometer unless this automatic pop-up feature is disabled by a press and hold of the function switch while in range display mode. Automatic range pop-up feature will show that it is disabled by blinking twice. Likewise, automatic range pop-up can be reactivated by a press and hold of the function switch. Range will blink once when the automatic pop-up feature is reenabled.
- When the low fuel warning lamp turns on, there is approximately 3.79 L (1.00 USgal) of fuel remaining in the tank. Refuel as soon as possible.
- The range display is only updated when the vehicle is moving.
- After the range calculation reaches 16 km (10 mi) remaining, the range display will show "r Lo" to indicate that the vehicle will shortly run out of fuel.
- Resetting the low fuel warning lamp and range requires an ignition cycle change.
NOTE
| 1 | Speedometer |
| 2 | Tachometer |
| 3 | Voltmeter |
| 4 | Oil pressure |
| 5 | Air temperature |
| 6 | Fuel level |
| 7 | Function button |
| 8 | Indicator lamps |
Figure 1. Instruments: FLTRSE3