NOTE
The heated seat will automatically shut off after one hour of continuous operation. To reset the seat, push the heated seat switch to the off position. Then set the switch back to the desired heat setting.
Removal
NOTICE
Detach passenger seat strap before removing seat. Failure to do so can result in damage to rear fender paint. (00225a)
  1. Open right saddlebag cover and remove fastener from seat strap bracket.
  2. Pull upward on strap to free it from slot in bracket. Move passenger seat strap to side of seat.
  3. Remove mounting fastener to detach seat mounting bracket from top of rear fender.
  4. See Figure 1. Push seat rearward to free tongue from slot in the seat.
  5. Separate the seat connector half from the power connector half.
  6. Remove seat.
Installation
1. Mate the heated seat connector half to the power connector half found in the frame backbone Y to the left of the battery.
2. See Figure 2. Place seat on frame backbone.
3. See Figure 1. Firmly push front of seat downward and rearward until tongue engages slot in seat.
4. Push seat forward until rear fender seat retention nut is centered in hole of mounting bracket.
5. Install seat mounting fastener. Tighten to 5.4–8.1 N·m (48–72 in-lbs).
NOTE
If the seat retention nut is damaged or lost, see service manual for instructions.
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
6. See Figure 3. Install end of seat strap in slot of seat strap bracket. Install seat strap bracket fastener. Tighten to 5.4–8.1 N·m (48–72 in-lbs).
7. Pull up on seat to verify that it is properly secured.
Figure 1. Seat Tongue
1Connector
2Mounting slot
Figure 2. Seat
Figure 3. Seat Strap Bracket Screw (typical)