Entering Program Mode
Read all directions first.
NOTE
To program a fob, it is necessary to put the receiver on the motorcycle into program mode.
  1. Turn ignition knob to IGNITION.
    2. NOTE
    • Verify that both saddlebags and the Tour-Pak power locks are functioning correctly when using the saddlebag/Tour-Pak lock switch.
    • Leave the Tour-Pak lid open during programming to see the Tour-Pak power lock hook move during lock and unlock events.
  2. See Figure 1. Press UNLOCK on the saddlebag/Tour-Pak lock switch to set locks to the unlocked position. Wait 5 seconds.
  3. Press LOCK once on the saddlebag/Tour-Pak lock switch.
  4. Press UNLOCK on the saddlebag/Tour-Pak lock switch 3 times in a row.
  5. Press LOCK on the saddlebag/Tour-Pak lock switch 3 times in a row.
  6. Press and hold UNLOCK for 5 seconds. After 5 seconds, the actuators will cycle the locks to locked then back to unlocked. Release the switch. The receiver is now beginning its program cycle.
  7. Wait 11 more seconds. The actuators will once again cycle to lock then back to unlock. The receiver is now in program mode.
1Unlock
2Lock
Figure 1. Saddlebag/Tour-Pak Power Lock Switch
Program Mode
NOTE
Pressing lock or unlock on the saddlebag/Tour-Pak lock switch during program mode will cause program mode to end.
  1. See Figure 2. Press and release the LOCK button on fob number 1 repeatedly until you hear the actuators lock. Verify the fob is programmed by pressing UNLOCK.
  2. After fob number 1 is programmed, wait 5 seconds until the actuators cycle to lock then back to unlock. Now program fob number 2.
  3. Repeat previous steps to program fob number 2.
  4. The receiver will remain in program mode for 30 seconds. Repeat steps 1 and 2 to program any other fobs.
  5. To exit program mode, perform one of the following:
    1. Wait 30 seconds.
    2. Press lock or unlock on the saddlebag/Tour-Pak lock switch.
    3. Remove power lock fuse.
1Lock
2Unlock
3Key
Figure 2. Power Lock Fob
Replacing the Battery
  1. See Figure 3. Slowly turn a thin screwdriver blade in the thumbnail slot (1) on the side of the fob to separate the two halves.
  2. Remove the battery (2) and discard.
    3. NOTE
    Dispose of old battery in accordance with local regulations.
  3. Install a new battery (Panasonic 2032 or equivalent) with the positive (+) side facing up.
  4. Align the two halves of the fob and snap together.
1Thumbnail slot
2Battery
Figure 3. Power Lock Fob Battery