NOTICE
Control wiring is routed inside handlebar and may be pinched or cut if controls are rotated too far. Electrical damage to control wiring can result. See Service Manual Supplement or see a Harley-Davidson dealer. (00363a)
1. Loosen control assembly fasteners only enough to allow movement for adjustment purposes, use caution to not loosen too much to allow cable pinch.
2. See Figure 1. Align left hand controls for operator comfort with clamping surface (1) located within the range marks (2).
3. Tighten switch housing fasteners to 4–5.1 N·m (35–45 in-lbs).
4. See Figure 2. Align right hand controls for operator comfort with clamping surface (1) located within the range marks (2).
5. Tighten switch housing fasteners to 4–5.1 N·m (35–45 in-lbs).
1Clamping surface
2Range marks
Figure 1. Left Hand Control Assembly to Handlebar Alignment
1Clamping surface
2Range marks
Figure 2. Right Hand Control Assembly to Handlebar