Operation
See Figure 1. Open lock and release draw catch to open the Tour-Pak.
CAUTION
Do NOT pull on any electrical wires. Pulling on electrical wires may damage the internal conductor causing high resistance, which may result in minor or moderate injury. (00168a)
See Figure 2. The Tour-Pak and rack assembly attaches to two rear mounting points on each side of the vehicle. The Tour-Pak may be removed from the motorcycle if the radio antenna wiring is rerouted.
1Key
2Lock
3Draw catch
Figure 1. Tour-Pak Lock and Draw Catch
1Rear Tour-Pak mount
2Front Tour-Pak mount
3Passenger backrest mounts
Figure 2. Tour-Pak Mounting Points
Removal
Before removing the Tour-Pak the antenna cable and internal light power harness must be disconnected. See Maintenance and Lubrication → Radio Antenna Installation: FLHTCSE2.
  1. Locate Tour-Pak power connector between seat and fender strut cover on left side of motorcycle.
  2. Unplug power connector and tuck cable assembly between seat and fender strut cover.
    3. NOTE
    See Figure 3. With the antenna mast mounted on the Tour-Pak antenna mount, the coaxial adapter allows connecting the antenna cable to the chassis antenna mount. With Tour-Pak removed, the adapter may be removed and antenna mast threaded directly onto the chassis antenna mount.
  3. See Figure 4. Unscrew upper antenna cable from coaxial adapter.
  4. See Figure 5. To remove the Tour-Pak, press the release buttons shown (both right and left sides of rack) and pull the rotary latch lever back.
  5. Carefully lift the rear of the Tour-Pak up and pull toward the rear to disengage front docking points.
  6. Place Tour-Pak on a work bench.
Figure 3. Coaxial Adapter For Antenna
Installation
  1. See Figure 2. While standing behind the motorcycle, place the Tour-Pak front rack notches into the front docking points. This may require some gentle squeezing or spreading of the rack legs.
  2. See Figure 5. Pull the rotary latches back into their rearmost position. Position the rear rotary latches over the rear docking points, making certain the latches and rack legs fit into the neck of the rear docking points. This may require some gentle squeezing or spreading of the rack legs or docking point brackets.
  3. Push downward and close the rotary latches by pressing the latch lever as far forward as it will go. You will hear a click when the latch is in place. If the latch does not easily close, do not force. Recheck alignment as described in Step 2.
  4. Reconnect power connector and antenna cable.
Figure 4. Upper Antenna Cable
Figure 5. Tour-Pak Rotary Latch