1. See Figure 1. Make certain ignition switch is turned off.
2. Remove three screws to detach the tail lamp assembly from base.
3. Push bulb into socket and rotate 1/4 turn counterclockwise. Pull bulb from socket.
4. Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner.
5. Coat base of new bulb with ELECTRICAL CONTACT GREASE (Part No. 99861-90).
6. Orient index pins on new bulb with pin guides inside bulb socket. Push bulb in and turn clockwise to lock in place.
7. Install tail lamp assembly to base with three screws. Tighten screws to 2.3–2.7 N·m (20–24 in-lbs).
WARNING
Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
8. Turn ignition on and test for proper tail lamp operation.
1Screws (3)
2Tail lamp assembly
3Bulb
Figure 1. Tail Lamp Assembly: Tombstone Style