General
WARNINGThe automatic-on headlamp feature provides increased visibility of the rider to other motorists. Be sure headlamp is on at all times. Poor visibility of rider to other motorists can result in death or serious injury. (00030b)
See Figure 1. The ignition/headlamp key switch controls electrical functions of the motorcycle.
See the YOUR OWNER'S MANUAL section at the beginning of this manual. Be sure to record all your key numbers in the space provided at the front of this book.
NOTICE
Protect your vehicle against theft. Failure to lock the motorcycle after parking could result in theft and/or equipment damage. (00151b)
NOTICE
Do not lubricate barrel locks with petroleum based lubricants or graphite. Inoperative locks may result. (00152a)
Lock/Unlock Switch
When the ignition/headlamp switch is locked, it cannot be rotated to a different position. The ignition switch can only be locked in the OFF or ACCESSORY position. The switch cannot be locked in the IGNITION position.
- Lift the switch cover.
- See Figure 1. Insert the key and turn counterclockwise to lock the switch. To unlock the switch, turn the key clockwise.
- Remove the key and close the switch cover.
Selecting Switch Position
See Figure 1. After the switch has been unlocked, it can be rotated to any position.
Refer to Table 1 for ignition/headlamp key switch operation.
NOTE
Harley-Davidson recommends removing key from ignition/headlamp key switch and fork lock before operating motorcycle. If you do not remove key, it can fall out during operation.
The key can be removed while the switch is in any position.
The lamps illuminate when the switch is in the IGNITION position, as required by law in some localities.
Table 1. Ignition/Headlamp Switch Positions: FLHRSE3
FUNCTION | OPERATION |
|---|---|
IGN | When switch is in IGNITION position, the motorcycle can be started and all lamps and accessories will operate.* |
OFF | When switch is in OFF position, the ignition, lamps and accessories are off. The switch can be locked in the OFF position. |
ACC | When switch is in ACCESSORY position, all the lamps and accessories will operate but the engine cannot be started. Brake lamp and horn can be activated. The switch can be locked while in the ACCESSORY position.* |
*International models have an additional function - position lamp and tail lamp are also on. | |
| 1 | Lock |
| 2 | Unlock |
| 3 | Accessory |
| 4 | Off |
| 5 | Ignition |
Figure 1. Ignition/Headlamp Key Switch