Description | Part Number | Qty. |
---|---|---|
OIL FILTER WRENCH | HD-42311 | 1 |
OIL FILTER WRENCH | HD-44067-A | 1 |
1. | Ride motorcycle until engine is warmed up to normal operating temperature. | |
2. | See Maintenance and Lubrication → Checking and Adding Oil → Engine Oil Dipstick Location: FXDFSE. Unthread the cap to remove the oil filler plug/dipstick. | |
3. | See Figure 1. Remove the engine oil drain plug with o-ring. Allow oil to completely drain into a suitable container. | |
NOTICE Use Harley-Davidson oil filter wrench for filter removal. This tool can prevent damage to crankshaft position sensor and/or sensor cable. (00192b) | ||
4. | See Figure 2. Remove the oil filter using the OIL FILTER WRENCH (Part Number:HD-42311) or OIL FILTER WRENCH (Part Number:HD-44067-A). Clean the oil filter mount flange of any old gasket material. NOTE Dispose of oil and oil filter in accordance with local regulations. | |
5. | See Figure 3. Lube the gasket on new oil filter with engine oil and install new filter. Hand tighten oil filter 1/2-3/4 turn after gasket contacts filter mounting surface. | |
6. | See Figure 1. Install oil tank drain plug. a. Inspect o-ring for tears or damage. Replace if required. Wipe any foreign material from plug. b. Install o-ring and drain plug and tighten to 19–28.5 N·m (14–21 ft-lbs). | |
NOTICE Do not overfill oil. Doing so can result in oil carryover to the air cleaner leading to equipment damage and/or equipment malfunction. (00190b) | ||
7. | Refer to Maintenance and Lubrication → Engine Lubrication: Synthetic Oil → Recommended Synthetic Engine Oils. Fill oil tank with the correct amount of oil. Use the proper grade of oil for the lowest temperature expected before next oil change. Use 2.4 L (2.5 qt) of engine oil for a capacity refill. | |
8. | Check engine oil level using COLD CHECK procedure. | |
9. | Start engine and carefully check for oil leaks around drain plug and oil filter. | |
10. | Check engine oil level using HOT CHECK procedure. |
1 | Thin oil film ONLY |
2 | Oil filter |
3 | Mounting plate |