1.	Remove the main fuse. See Service Procedures → Fuses.
2.	Remove the trim ring. Support the lens and reflector.
3.	See Figure 1. Remove the spade connectors from the bulb.
4.	Pull the bulb holder from the lens and reflector.
5.	Pull bulb out to remove. Push bulb in to install.
6.	Install the bulb and holder.
7.	Match the reflector tab to the adapter ring notch.
8.	Install the trim ring. Tighten to: Torque: 1–1.5 N·m (9–14 in-lbs) Trim ring screw

Figure 1. Position Lamp