XL883L, XL1200T and Models with Standard Style Tail Lamp
| 1. | See Figure 1. Remove two screws and lens from base. NOTE Remove the 4-pin connector to ease bulb removal. | |
| 2. | Pull bulb assembly from lens. Remove bulb. | |
| 3. | Coat base of new bulb with ELECTRICAL CONTACT GREASE. Install new bulb. | |
| 4. | Install (push) bulb assembly to lens. | |
| 5. | If removed, connect connector to circuit board. | |
| 6. | Install lens to base with two screws. Tighten to: Torque: 2.3–2.7 N·m (20–24 in-lbs) Tail lamp lens screws | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 7. | Turn on ignition. Check operation of all lamps. |
| 1 | Lens |
| 2 | Base |
| 3 | Tail lamp connector |
| 4 | Bulb socket |
Figure 1.
XL1200C
Although similar in appearance to the standard style tail lamp, the tail lamp on XL1200C model is an LED assembly. See a dealer or service manual for replacement.
XL883N, XL1200NS, XL1200X, XL1200XS, XL1200CX
The tail and stop lamps are dual filament turn bulbs in the rear turn signal bullet housings with red lenses. To replace a tail or stop lamp, replace the turn signal bulbs. See Service Procedures → Turn Signal Bulb Replacement: Incandescent.
XL883N, XL1200NS, XL1200CX, XL1200X, XL1200XS Models with LED Turn Signal Tail and Stop Lamps
On International and Japan XL883N, XL1200NS, XL1200CX, XL1200X and XL1200XS models, the rear turn signal/tail lamps is an LED assembly. On XL1200CX models for certain markets, the center stop lamp is an LED assembly. There are no replacement bulbs for this style lamp. See a dealer or service manual for replacement.