The TRIP switch activates the trip odometers. It is used to activate the odometer display to scroll through the optional screens. With the ignition off, the TRIP switch can activate time or odometer displays. Refer to Table 1.

See Figure 1. Press the HORN switch to activate the horn. The horn can be activated for up to 10 seconds at a time. If the HORN switch is held for a longer period, the horn will automatically deactivate. Refer to Table 1.

See Figure 1. Press the high beam switch to activate the high beam. The (blue) high beam indicator lamp is lit when the high beam is on. Refer to Table 1.

Low beam: See Figure 1. Press the bottom of the switch to activate the low beam.

Flash to pass: When the low beam switch is on, press and release the flash to pass switch to flash the high beam before passing another vehicle. The high beam indicator lamp is illuminated as long as the flash to pass switch is pressed.

When in accessory, press the flash to pass switch to activate the headlamp. Refer to Table 1.

Activate: See Figure 1. Press the left turn signal switch to activate the left turn signal. Refer to Table 1.

Manual Operation: Press and release the turn signal switch a second time.

Automatic Operation: The turn signal lamps automatically cancel when a full turn has been detected based on speed, acceleration and turn completion.

The lamps also cancel if the turn signal has been activated for a prolonged period (20 flashes) while the motorcycle speed is greater than 11 km/h (7 mph). If the motorcycle is stopped or moving slower than this speed, the turn signal continues flashing.