Replacing Turn Signal Bulb
| 1. | See Figure 1. Insert coin in notch. Carefully twist until the lens cap pops out of the lamp housing. | |
| 2. | While pushing bulb in, rotate counterclockwise to remove. Remove bulb. | |
| 3. | Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner. | |
| 4. | Apply ELECTRICAL CONTACT LUBRICANT to the contacts in socket and at bottom of the new bulb. | |
| 5. | Align pins on new bulb with guides in bulb socket. Push and rotate new bulb clockwise into socket. | |
| 6. | With the notch at the bottom, snap the lens cap onto the lamp housing. | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 7. | Check operation of all lamps. |
Figure 1. Remove Lens