Once armed, if the motorcycle is moved or lifted up off of its jiffy stand and the fob is not present, the alarm will warn the operator with three alternate flashes of the turn signals and a chirp of the siren.
Within four seconds, if the motorcycle is back on its jiffy stand and no further motion is detected, the system will remain armed without activating the alarm.
If the motorcycle motion continues, the system will issue a second warning four seconds after the first.
During warnings and alarms, the starter motor and the ignition circuits remain disabled.
Alarm Activation
If the security system is still detecting motion after a second warning, the system will activate the alarm.
When activated, the security system will:
Duration: The alarm will stop within 30 seconds and if no motion is detected, the alarm will not restart.
However, if motorcycle motion continues the system will repeat the 30 second alarm and recheck for motion. The alarm will repeat this 30 second alarm cycle for five minutes (10 cycles) or until the alarm is deactivated.
The alarm will also activate the LED, vibration or audible modes of an optionally purchased Harley-Davidson Security Pager. The range of a pager can be up to 0.8 km (½ mi). See a Harley-Davidson dealer for details.
Alarm Deactivation
Key fob: Bring the fob to the motorcycle. After the module identifies that the fob is present, the system will terminate the alarm.
PIN entry: Enter the PIN to deactivate the alarm. If an error is made while entering the PIN, wait until the alarm is between cycles to enter the PIN.