Changing Units of Measurement
Time
Press and release the TRIP switch to cycle through the odometer displays to the time display. To set the time:
  1. See Figure 1. Press and release the TRIP switch (1) until time (hour and minutes) is displayed. Press and hold the TRIP switch until 12h (2) begins to blink in the speedometer display window. Release the switch.
  2. Press and release the TRIP switch once to advance to a blinking 24h or military style time display. Each time you press and release the switch, the display switches between 12h and 24h.
  3. When the desired time style is displayed, press and hold the TRIP switch until the hours display (3) is blinking.
  4. Press and release the TRIP switch repeatedly to advance the hours.
  5. When the correct hour is displayed, press and hold the TRIP switch until the minutes display (4) starts blinking.
  6. Press and release the TRIP switch repeatedly to advance the minutes display.
  7. When the correct minutes are displayed (5), press and hold the TRIP switch until the display advances to AM or PM (6).
  8. NOTE
    AM or PM does not appear in the regular time display. The motorcycle uses the selection for diagnostic purposes.
  9. In the 12h display, AM or PM flashes. Select AM or PM with the TRIP switch. Press and hold the switch for five seconds.
  10. Turn the OFF/RUN switch to OFF.
1Trip switch
212 hour or 24 hour
3Hour select
4Minute select
5Hour and minutes set
6AM or PM
Figure 1. Time Displays
Tip Message
WARNING
If tip occurs, check all controls for proper operation. Restricted control movement can adversely affect the performance of the brakes, clutch or ability to shift, which could result in loss of vehicle control and death or serious injury. (00350a)
See Figure 2. When the motorcycle is tipped over, the word "tIP" (1) appears in the odometer window. The engine does not start until reset.
To reset the odometer tIP message, see Operation → Starting after Tipover.
No Fob Message
See Figure 2. If the motorcycle has a security system and is driven off leaving the fob behind, "NO FOB" (2) is displayed in the odometer window as the motorcycle starts moving. The display lasts for 10 seconds as a reminder to retrieve the fob.
Without the fob, the motorcycle can only be started with a manual PIN entry to disarm the security system. See SECURITY SYSTEM → Arming and Disarming.
Sidestand Message
See Figure 2. On international (HDI) models, if the motorcycle is placed into gear while the jiffy stand is down a 'SidEstAnd' (3) message is displayed. See Controls and Indicators → Jiffy Stand Interlock: International Models.
1Tip over
2No fob
3Jiffy stand down
Figure 2. tIP, NO FOB and SidEStAnd