Removal
Solo Seat
| 1. | See Figure 1. Remove seat. |
Two-Up One-Piece Seat
NOTE
The seat screw may be difficult to access if the Tour-Pak is in the forward position. If necessary, see Operation → TOUR-PAK to temporarily move the Tour-Pak.
| 1. | Open Tour-Pak lid. | |
| 2. | Open one of the saddlebag lids. | |
| 3. | See Figure 2. Remove screw to release seat strap from bracket. | |
NOTICE Detach passenger seat strap before removing seat. Failure to do so can result in damage to rear fender paint. (00225a) | ||
| 4. | FLHRC: See Figure 5. Pull strap through slots in seat to remove. | |
| 5. | Remove screw to release seat from top of rear fender. NOTE Cover the seat mount mounting bracket with palm of hand to prevent damage to Tour-Pak. | |
| 6. | See Figure 3 and Figure 4. Raise rear of seat. Pull seat rearward to disengage the tongue from the slot in the seat. |
Installation
Solo Seat
| 1. | See Figure 1. Install seat. | |
| 2. | Pull up on seat to verify that it is secure. |
Two-Up One-Piece Seat
NOTE
Cover the seat mount mounting bracket with palm of hand to prevent damage to Tour-Pak.
| 1. | See Figure 3 and Figure 4. Align seat slot with tongue behind the fuel tank. Push seat forward to engage seat. | |
| 2. | See Figure 2. Secure seat bracket to rear fender with screw. Tighten. Torque: 5.4–8.1 N·m (48–72 in-lbs) Seat bracket screw | |
| 3. | Pull up on seat to check that it is properly secured. | |
| 4. | FLHRC: See Figure 5. Install strap through slots in seat. | |
| 5. | See Figure 2. Insert strap in slot on seat strap bracket. | |
| 6. | Install screw and washer. Tighten. Torque: 5.4–8.1 N·m (48–72 in-lbs) Seat strap bracket | |
| 7. | Close the saddlebag lid. | |
| 8. | Close Tour-Pak lid. |
NOTE
Install Tour-Pak back in desired position if removed. See Operation → TOUR-PAK.
| 1 | Seat nut |
Figure 1. Solo Seat
| 1 | Seat strap screw |
| 2 | Seat strap |
| 3 | Seat screw |
Figure 2. Seat Strap Screw
Figure 3. Seat Tongue
Figure 4. Seat Mounting Slot
Figure 5. Strap Slots: FLHRC