See Figure 1. Vehicle off: Press the trigger switch (1) to display the accumulated mileage in the odometer. Hold trigger switch to turn on accessory mode, allowing for operation of the emergency lamps for up to 30 minutes. Vehicle in accessory/ignition mode: Press the trigger switch to cycle through the odometer functions. Refer to Table 1.

See Figure 1. Press the high beam switch (2) to activate the high beam. The (blue) high beam indicator lamp is lit when the high beam is on. Refer to Table 1.

Low beam: See Figure 1. Press the bottom of the low beam/flash to pass switch (3) to activate the low beam.

Stealth mode: Press and hold the bottom of the switch to activate stealth mode. When in stealth mode, all vehicle lamps are deactivated except for the instrument lamps and brake lamp. Press the bottom of the switch or the emergency lamp switch to deactivate stealth mode.

When in accessory, press the flash to pass switch to activate the headlamp. Refer to Table 1.

See Figure 1. The voice recognition switch (4) activates other police communications equipment not sold by Harley-Davidson. Refer to Table 1.

See Figure 1. The CRUISE/SET/RESUME switch (5) automatically regulates the speed of the vehicle. See Operation → Cruise Control for detailed operation. Refer to Table 1

CRUISE: Press the CRUISE switch straight in to enable cruise control. The cruise control indicator lights orange. Pressing the CRUISE switch again turns off cruise control.

SET/-: With cruise control enabled, press SET/- to set the cruising speed. The cruise control indicator lights green. While at cruising speed, press SET/- to decrease the regulated speed.

RESUME/+: If cruise control is disengaged (such as a braking event), press RESUME/+ to resume the previous cruising speed. While at cruising speed, press RESUME/+ to increase speed.

See Figure 1. Press the siren switch (6) straight in to alternate between on and off.

Siren On: Press the switch to the right to select yelp mode. Each press will change the mode.

Siren Off: Press the switch to the right to pulse the siren in YELP mode.

Activate: See Figure 1. Press the left turn signal switch (7) to activate the left turn signal. Refer to Table 1.

Manual Operation: Press the left turn signal switch to cancel the right turn signal.

Automatic Operation: The turn signal lamps automatically cancel when a full turn has been detected based on speed, acceleration and turn completion.

The lamps also cancel if the turn signal has been activated for a prolonged period (20 flashes) while the motorcycle speed is greater than 7 mph (11 km/h). If the motorcycle is stopped or moving slower than this speed, the turn signal continues flashing.

See Figure 1. The horn is operated by pressing the horn switch (8). The horn can be activated for up to 10 seconds at a time. If the horn switch is held for a longer period, the horn automatically deactivates. Refer to Table 1.