Hazard Warning 4-Way Flasher

See Figure 1. The hazard switch (1) is used to leave a stranded motorcycle in the 4-way flashing mode. With the flashers, the motorcycle can be left with the ignition off until assistance is found. Refer to Table 1.

With the OFF/RUN switch in the run position, press on the hazard warning triangle to activate the 4-way flashers.

NOTE

Security models:The fob must be present when turning on the 4-way flashers and when canceling the flashers.
The four-way flashers will operate when the vehicle is tipped over regardless of OFF/RUN switch position. See Operation → Starting after Tipover.

Turn OFF/RUN switch to the off position. The 4-way flashers continue for 2 hours or until cancelled by the rider.
To cancel, turn the OFF/RUN switch to the run position. Press the warning triangle above the start switch.

OFF

See Figure 1. Press the engine OFF/RUN switch to off (2) to shut off the engine. Refer to Table 1.

RUN

See Figure 1. Push the engine OFF/RUN switch to run (3) to enable engine start and run. The engine OFF/RUN switch must be in the run position to start or operate the engine. Refer to Table 1.

Right Turn Signal

Activate:

See Figure 1. Press the right turn signal switch (4) to activate the right turn signal. Refer to Table 1.

Cancel:

Manual Operation: Press the right turn signal switch to cancel the right turn signal.

Automatic Operation: The turn signal lamps automatically cancel when a full turn has been detected based on speed, acceleration and turn completion.

The lamps also cancel if the turn signal has been activated for a prolonged period (20 flashes) while the motorcycle speed is greater than 7 mph (11 km/h). If the motorcycle is stopped or moving slower than this speed, the turn signal continues flashing.

NOTE

Front turn signal lamps also function as running lamps. This feature may not be available in all markets.

Emergency Lamp Switch

See Figure 1. Press the emergency lamp switch (5) to activate both front and rear emergency lamps. The indicator lamp alternates between green and orange to indicate that the emergency lamps are activated. Refer to Table 1.

FRONT: Press the switch to the left to activate the front emergency lamps. The indicator lamp with illuminate green to indicate that the front emergency lamps are activated.

REAR: Press the switch to the right to activate the rear emergency lamps. The indicator lamp with illuminate orange to indicate that the rear emergency lamps are activated.

Emergency lamps continue to operate when the ignition is switched OFF. To shut down the motorcycle, completely turn off the emergency lamps and cycle the ignition ON and then OFF.

NOTE

On non-U.S. police models, the alternating flasher is removed at the factory and placed in the saddlebag. All of the switches are still enabled but the front emergency lights will not flash or illuminate without the flasher.

Start

See Figure 1. Switch the OFF/RUN switch to the run position (3). Shift the transmission to neutral. The neutral (green) indicator illuminates. See Operation → Starting the Engine.
Press the start switch (6) to operate the starter motor. Refer to Table 1.

NOTE

When the starter is activated, the headlamp is momentarily turned off to reduce battery load.
If the engine does not start, the starter motor runs for ten seconds and stops. Release the start switch. Press the start switch to try again. After several unsuccessful attempts to start the engine, see a Harley-Davidson dealer.

1	Hazard warning
2	Off
3	Run
4	Right turn signal
5	Emergency lights
6	Start

Figure 1. Right Hand Switch Module

Table 1. Right Hand Control Switches

SWITCH	NAME	FUNCTION
	Hazard	Press to activate the 4-way flashers.
	Off	Press to stop the engine or to prevent the engine from starting.
	Run	Press to allow the engine to start.
	Right turn	Press to signal a right turn.
	Emergency lights	Three-way switch, operates emergency lights.
	Start	Press to start the engine.