NOTE
Do not remove trim ring for headlamp adjustment.
  1. Set headlamp beam:
    1. LED: Set headlamp to low beam.
    2. Halogen: Set headlamp to high beam.
  2. See Figure 1. Insert a 5/32 in ball end hex wrench through adjuster slots in trim ring.
    1. Horizontal: Turn the horizontal adjusting screw (1) to adjust light beam left and right.
    2. Vertical: Turn the vertical adjusting screw (2) to adjust light beam up and down.
  3. Align headlamp.
    1. LED: See Service Procedures → Check Headlamp Alignment → Headlamp Alignment: LED Type (typical).
    2. Halogen: See Service Procedures → Check Headlamp Alignment → Headlamp Alignment: Quartz Halogen Type.
1Horizontal adjuster
2Vertical adjuster
Figure 1. Headlamp Adjusters (typical)