FCC Notices
Changes or modifications to this unit not expressly approved by the manufacturer could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15, Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
  1. Reorient or relocate the receiving antenna.
  2. Increase the distance between the equipment and the receiver.
  3. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  4. Consult dealer or experienced radio/TV technician for help.
Receiver Installation
Remote garage door opener function is not compatible with all garage door openers. See your Harley-Davidson dealer for details.
  1. Unplug the power cord from the garage door drive unit to prevent door activation during installation.
  2. Select an unswitched 110V power outlet that is located either highest in the garage, or the closest to the front of the garage, or both.
  3. NOTE
    • With some brands of garage door opener systems, it may be necessary to plug in the Harley-Davidson receiver at a location some distance from the door opener. If the Harley-Davidson receiver is plugged in too close to the original opener receiver, effective transmission range may be significantly reduced on both systems.
    • Opener may not function properly with steel buildings.
  4. Connect the stripped end of the Harley-Davidson garage door opener receiver wires to the terminals that activate the door opener drive unit at one of these locations:
    1. The existing wall mounted garage door opener button.
    2. The garage door drive unit to which the garage door opener button is connected.
  5. NOTE
    • Refer to the door opener manufacturer's documentation for terminal locations and connections.
    • Do not remove original wires from the original connections on the door opener button or on the drive unit terminals.
  6. Route the receiver wires to the selected power outlet location.
  7. See Figure 1. Plug the connector on the receiver wires into the receptacle (1) on the back of the receiver.
  8. Plug the receiver into the selected power outlet.
  9. Reconnect the garage door drive unit into the power outlet.
  10. Press the wall mounted garage door opener button to set the button operation.
Program the Receiver and Transmitter
The receiver must be programmed to receive the transmitter frequency. This process may require two people depending on how far apart the receiver and transmitter are during the programming process.
  1. Check that a red light is visible on the front of the Harley-Davidson garage door opener receiver, indicating power to the receiver.
  2. See Figure 1. Press and hold the Set button (3) on the Harley-Davidson garage door opener receiver. The LED (2) blinks continuously while the Set button is pressed.
  3. Push the OFF/RUN switch to RUN. Switch the headlamp beam switch using one of these sequences. When the receiver receives a signal from the transmitter, the LED on the transmitter turns off.
    1. Starting from Low beam, switch High, then Low.
    2. Starting from High beam, switch Low, then High.
  4. Release the Set button on the receiver.
  5. NOTE
    Clear all obstructions away from between the transmitter and receiver before testing the operation of the garage door opener.
  6. Test the garage door opener, high beam, and low beam headlamp operation.
  7. NOTE
    When the transmitter is activated by toggling the headlamp switch, the red LED on the transmitter illuminates for one second to indicate that the transmitter is functioning correctly.
  8. Push the OFF/RUN switch to OFF.
1Wire connector/plug receptacle
3Set button
Figure 1. Garage Door Opener Receiver