NOTE
Do not remove trim ring for headlamp adjustment.
  1. Set headlamp beam:
    1. Quartz halogen: Set headlamp to high beam.
    2. LED, fork-mounted fairing: Set headlamp to low beam.
    3. LED, frame-mounted fairing: Set headlamp to high beam.
  2. All except frame-mounted fairing: See Figure 1. Insert a 5/32 in ball end hex wrench through adjuster slots in trim ring.
    1. Horizontal: Turn the horizontal adjusting screw (1) to adjust light beam left and right.
    2. Vertical: Turn the vertical adjusting screw (2) to adjust light beam up and down.
  3. NOTE
    • Frame-mounted fairing models allow only vertical adjustment.
    • Any of three tools can be used: 9 mm socket, 6 mm hex or T15 Torx.
    • Do not force adjuster past the point that resistance is felt.
  4. Frame-mounted fairing models: See Figure 2.
    1. Turn the adjuster to adjust light beam up and down.
    2. See Maintenance and Lubrication → Adjust Auxiliary . Adjust headlamp light beam.
1Horizontal adjuster
2Vertical adjuster
Figure 1. Headlamp Adjusters: All except Frame-Mounted Fairing (typical)
Figure 2. Headlamp Adjuster: FLTRU, FLTRX, FLTRXS
Video Link
WARNING
Always review the appropriate service procedure prior to performing it. This video is intended to supplement, not replace, documented service procedures. Attempting service procedures without the proper training, tools, equipment, and manuals could result in death or injury to you or others. This could also damage the motorcycle or cause the motorcycle to operate improperly. (10406a)
Video 1. Video Link