Hazard Warning 4-Way Flasher

See Figure 1. The hazard switch (1) is used to leave a stranded motorcycle in the 4-way flashing mode. With the flashers, the motorcycle can be left with the ignition locked until assistance is found. Refer to Table 1.

With the ignition switch in the IGNITION or ACC position, press on the hazard warning triangle to activate the 4-way flashers.

NOTE

Security models: The fob must be present when turning on the 4-way flashers and when canceling the flashers.
The four-way flashers will operate when the vehicle is tipped over regardless of ignition switch position. See Operation → Starting after Tipover.

Turn ignition off. The 4-way flashers continue for 2 hours or until cancelled by the rider.
To cancel, turn the ignition to ACC or IGNITION. Press the warning triangle above the start switch.

Start

See Figure 1. The start switch (5) is on the right handlebar control module. Refer to Table 1.

Switch the OFF/RUN switch to the run position (3). Shift the transmission to neutral. The neutral (green) indicator illuminates. See Operation → Starting the Engine.
Turn ignition on. Press the start switch (5) to operate the starter motor.

NOTE

When the starter is activated, the headlamp is momentarily turned off to reduce battery load.
If the engine does not start, the starter motor runs for ten seconds and stops. Release the start switch. Press the start switch to try again. After several unsuccessful attempts to start the engine, see a Harley-Davidson dealer.

OFF

See Figure 1. Press the engine OFF/RUN switch to OFF (2) to shut off the engine. Refer to Table 1.

After turning off the engine. Turn the ignition switch to OFF to disconnect the electric power.

RUN

See Figure 1. Push the engine OFF/RUN switch to RUN (3) to enable engine start and run. The engine OFF/RUN switch must be in the RUN position to start or operate the engine. Refer to Table 1.

Right Turn Signal

Activate: See Figure 1. Press the right turn signal switch (4) to activate the right turn signal. Refer to Table 1.

Cancel: Press the right turn signal switch to cancel the right turn signal. For detailed operation, see Controls and Indicators → Turn Signal Switch Operation.

NOTE

Front turn signal lamps also function as running lamps. This feature may not be available in all markets.

1	Hazard
2	Off
3	Run
4	Right turn signal
5	Start

Figure 1. Right Hand Control Switches

Table 1. Right Hand Control Switches

SWITCH	NAME	FUNCTION
	Hazard	Press to activate the 4-way flashers.
	Start	Press to start the engine.
	Off	Press to stop the engine or to prevent the engine from starting.
	Run	Press to allow the engine to start.
	Right turn	Press to signal a right turn.