Low Beam/Flash to Pass
Low beam: See
Figure 1. Press the bottom of the switch to (4) activate the low beam.
Flash to pass: Press and release the flash to pass switch (4) to flash the high beam before passing another vehicle. The high beam indicator lamp in the speedometer face is illuminated as long as the flash to pass switch is pressed.
When in accessory, press the flash to pass switch to activate the headlamp. Refer to
Table 1.
Left Turn Signal
Activate: See
Figure 1. Press the left turn signal switch (5) to activate the left turn signal. Refer to
Table 1.
Cancel: Press the left turn signal switch to cancel the left turn signal.
NOTE
Figure 1. Left Hand Switch Module
Table 1. Left Hand Control Switches
SWITCH | NAME | FUNCTION |
---|
| Trip | Press to alternate odometer displays. |
| Horn | Press to sound the horn. |
| High beam | Press to switch the headlamp to high beam. |
| Low beam/ flash to pass | Press to switch the headlamp to low beam. Press and release to flash the high beam. In ACC, press to activate the headlamp. |
| Left turn | Press to activate the left turn signal. |
Cruise Control
Cruise: Press the cruise switch straight in to enable cruise control.The cruise control indicator lights amber. Pressing the switch again turns off cruise control.
SET/-: With cruise control enabled, press SET/- to set the cruising speed. The cruise control indicator lights green. While at cruising speed, press SET/- to decrease the regulated speed.
RES/+: If cruise control is disengaged (after braking or rolling the throttle through the roll-off switch), press RES/+ to resume the previous cruising speed. While at cruising speed, press RES/+ to increase speed.
Figure 2. Cruise Control
Table 2. Cruise Control Switch
SWITCH | NAME | FUNCTION |
---|
| Cruise | Press to turn on cruise. |
| Set | Press to set the cruise speed. Tap down to decrease speed in increments. |
| Resume | Press to resume cruise. Tap up to increase set speed in increments. |