General
NOTICE
The engine should be allowed to run slowly for 15-30 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00563b)
Rolling the throttle before starting the motorcycle is unnecessary.
Starting
WARNING
Shift transmission to neutral before starting engine to prevent accidental movement, which could result in death or serious injury. (00044a)
  1. Turn ignition switch to IGNITION position. Do not roll the throttle.
  2. See Figure 1. With security fob present, set the OFF/RUN switch to RUN.
    3. NOTE
    The check engine lamp will light when the ignition is turned on. You will hear the fuel pump run for a short time as it pressurizes the fuel system.
  3. Squeeze the clutch lever in against the hand grip. Shift transmission to neutral.
  4. Press the start switch to start the motorcycle.
    5. NOTE
    To allow enhanced lubrication of the engine before start, the engine will crank a number of turns before starting.
  5. When the engine has started, you can operate your motorcycle as you normally would after raising the jiffy stand.
NOTE
The ABS and TCS indicator lamps (models with) will flash until vehicle is moving approximately 5 km/h (3 mph).
1Hazard warning
2Off
3Run
4 Right turn signal
5 Cursor/select
6Back
7 Start
Figure 1. Right Hand Switch Module (Typical)