Description | Part Number | Qty. |
---|---|---|
OIL FILTER WRENCH | HD-42311 | 1 |
OIL FILTER WRENCH | HD-44067-A | 1 |
1. | Run motorcycle until engine is at normal operating temperature. NOTE To drain oil faster, remove the dipstick. | |
2. | Remove dipstick from oil tank. NOTE The drain pan must hold approximately 2.8 L (3.0 qt). | |
3. | Place a drain pan directly under the drain hose. | |
4. | See Figure 1. Pull drain hose clip (1) from frame tube. | |
5. | Direct hose (2) in front of the brake line bracket (3) into drain pan. | |
6. | Loosen worm drive clamp (4). Pull drain plug (5) from end of drain hose. NOTE Completely drain engine oil from oil tank. | |
7. | Allow oil to drain. | |
8. | Install drain plug into end of drain hose. | |
9. | Tighten worm drive clamp to 0.7–1.1 N·m (6–10 in-lbs). | |
10. | Route drain hose alongside frame tube. | |
11. | Clip hose to frame. |
1 | Clip |
2 | Hose |
3 | Bracket |
4 | Clamp |
5 | Plug |
1. | Place a drain pan under the oil filter. NOTE See Figure 2. Turn oil filter (1) counterclockwise to remove from mount (2). | |
NOTICE Use Harley-Davidson oil filter wrench for filter removal. This tool can prevent damage to crankshaft position sensor and/or sensor cable. (00192b) | ||
2. | Remove oil filter using OIL FILTER WRENCH (Part Number:HD-42311) or OIL FILTER WRENCH (Part Number:HD-44067-A). | |
3. | Drain engine oil. Discard oil filter. | |
4. | Clean any oil spills off crankcase and frame. |
1 | Filter |
2 | Mount |
1 | Contact surface |
2 | Filter gasket |
3 | Adapter |