XL 883R/L, XL 1200T and Models with Standard Style Tail Lamp
1. See Figure 1. Remove two screws and lens from base.
NOTE
Remove the 4-pin connector to ease bulb removal.
2. Pull bulb assembly from lens. Remove bulb from socket.
3. Coat base of new bulb with ELECTRICAL CONTACT GREASE. Install new bulb in socket.
4. Install (push) bulb assembly to lens.
5. If removed, connect [93] connector to circuit board.
6. Install lens to base with two screws. Tighten to 2.3–2.7 N·m (20–24 in-lbs).
WARNING
Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
7. Turn ignition on. Test for proper tail lamp operation.
1Lens
2Base
34-pin multilock connector
4Bulb socket
Figure 1. Tail Lamp Assembly
XL 1200C/CP/CA/CB
Though similar in appearance to the standard style tail lamp, the tail lamp on XL 1200C/CP/CA/CB models is an LED assembly. See a dealer or service manual for replacement.
XL 883N and XL 1200X/V
The tail and stop lamps are dual filament turn bulbs in the rear turn signal bullet housings with red lenses. To replace a tail or stop lamp, replace the turn signal bulbs. See Maintenance and Lubrication → Turn Signal Bulb Replacement: Bullet Style.
XL 883N and XL 1200X/V Models with LED Turn Signal Tail and Stop Lamps
On International and Japanese XL 883N and XL 1200X/V models, the rear turn signal/tail lamps are LED assemblies. There are not replacement bulbs for this style lamp. The caps on the rear turn signals are not removeable. See a dealer or service manual for assembly replacement.
Due to local regulations, this feature may not be found in all destinations.