| 1. | See Figure 1. Remove two screws to release lens from lamp housing. | |
| 2. | Push bulb in and rotate counterclockwise to remove bulb from socket. | |
| 3. | Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner. | |
| 4. | Liberally apply ELECTRICAL CONTACT LUBRICANT (Part No. 99861-02) to contacts in socket and at bottom of new bulb. | |
| 5. | Orient index pins on new bulb with pin guides inside bulb socket. Push bulb in and turn clockwise to lock in place. | |
| 6. | Seat lens in lamp and install two screws. | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 7. | Test turn signal operation. |
| 1 | Screws (2) |
| 2 | Lens |
| 3 | Bulb |
| 4 | Lamp housing |
Figure 1. Turn Signal Lamp Assembly: Flat Lens Style