1. See Figure 1. Make certain ignition switch is turned off.
2. Remove two screws and lens from base.
NOTE
For ease of bulb removal, the 4-Pin multilock connector can be removed from circuit board.
3. Remove (pull) bulb assembly from lens. Remove bulb from socket.
4. Coat base of new bulb with ELECTRICAL CONTACT GREASE (Part No. 99861-90). Install new bulb in socket.
5. Install (push) bulb assembly to lens.
6. If removed connect 4-Pin multilock connector to circuit board.
7. Install lens to base with two screws. Tighten screws to 2.3–2.7 N·m (20–24 in-lbs).
WARNING
Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
8. Turn ignition on and test for proper tail lamp operation.
1Lens
2Base
34-pin multilock connector
4Bulb assembly
Figure 1. Tail Lamp Assembly: Standard Style