Firmware Over The Air (FOTA) is a cellular, cloud-based method to update the vehicles software as needed using the vehicles telematics system. The Instrument Module (IM) displays a pop-up screen when software needs to be updated. The rider has the option to initiate or delay the update, unless a critical update is needed immediately.

NOTE

Poor cellular connection will prevent downloading of an update.
A FOTA update can only be installed when parked, with the jiffy stand down and not charging. System will not install or prompt the rider that there is an update available while in motion.
Propulsion mode is not available during update installation.
FOTA bundle updates are downloaded in the background while riding and charging the vehicle. The update prompt will not be offered until the bundle is fully downloaded.
Installation of these updates may take up to 40 minutes each.

To Update the Vehicle Software

NOTE

The IM may go to sleep before completing large installations. Installation will continue while the IM is in sleep mode and will wake up once the process is complete.

1.	The IM displays a pop-up when a software update is ready to be installed.
2.	Rider can initiate or delay software update, unless a critical update is needed.
3.	See Figure 1. Using the Left Hand Control Module (LHCM), select the navigate left (13) to initiate or select the navigate right (8) and press and hold for two seconds to delay downloading software.
4.	When rider initiates update, a progress bar displays on the IM to indicate the download percentage.
5.	See Figure 2. A pop-up displays on the IM when the software has been successfully downloaded.
6.	After update has completed, cycle vehicle's Ignition switch position (IGN) OFF. Wait 5 minutes to allow vehicle to perform a sleep cycle. Then normal use can be continued. NOTE Failure to perform a sleep cycle may result in faults displayed on the IM, and limited performance.

1	Cruise set/resume
2	Headlamp switch
3	Left hand control module
4	Cruise control
5	Trip/odometer
6	Navigate up
7	Menu
8	Navigate right
9	Home
10	Navigate down
11	Turn signal/cancel
12	Horn
13	Navigate left
14	OK/enter

Figure 1. Left Hand Control Module

Figure 2. Firmware Over The Air Update Ready