Clutch Lever
When starting the engine or shifting, hold the clutch lever (1) to cut off the drive of the rear wheel.
Flash to Pass
Flash to pass: When the low beam switch is on, press and release the flash to pass switch to flash the high beam before passing another vehicle. The high beam indicator lamp is illuminated as long as the flash to pass switch is pressed.
When in accessory, press the flash to pass switch to activate the headlamp. Refer to Table 1.
Horn
See Figure 1. Press the HORN switch to activate the horn. The horn can be activated for up to 10 seconds at a time. If the HORN switch is held for a longer period, the horn will automatically deactivate. Refer to Table 1.
High Beam
See Figure 1. Press the high beam switch to activate the high beam. The (blue) high beam indicator lamp is lit when the high beam is on. Refer to Table 1.
Low Beam
Low beam:See Figure 1. Press the bottom of the switch to activate the low beam.
Turn Signals
Activate:See Figure 1. Slide the left/right turn signal switch left or right to activate the left or right turn signal. Refer to Table 1.
Cancel: Press down to release the turn signal switch.
NOTE
Front turn signal lamps also function as running lamps. This feature may not be available in all markets.
NOTE
When changing lanes or turning, switch on the turn signal in advance and confirm that there is no vehicle behind. Turn off signal when completed to avoid affecting the normal driving of other vehicles so as to prevent accidents.
| 1 | Clutch lever |
| 2 | Flash to pass button |
| 3 | High beam/low beam |
| 4 | Hazard warning lamp button |
| 5 | Left/right turn signal switch |
| 6 | Horn button |
Figure 1. Left Hand Control Module (LHCM)
Table 1. Left Hand Control Switches
SWITCH | NAME | FUNCTION |
|---|---|---|
 | Hazard | Press the switch to activate the 4-way flashers. |
 | Horn | Press the switch to sound the horn. |
 | High beam | Press the switch to switch the headlamp to high beam. |
 | Low beam | Press the switch to switch the headlamp to low beam. |
 | Flash to pass | Press and release to flash the high beam when low beam on. |
 | Left/right turn | Slide switch left to activate left turn lamp. Slide switch right to activate right turn lamp. Push down to cancel. |
Hazard Warning 4-Way Flasher
See Figure 1. Use this switch to allow a stranded motorcycle to be left in the 4-way flashing mode. With the flashers, the motorcycle can be left with the ignition locked until help is found. Refer to Table 1.
- With the ignition switch in the IGNITION or ACC position, press on the hazard warning triangle to activate the 4-way flashers.
- Turn ignition off. The 4-way flashers continue for 2 hours or until cancelled by the rider.
- To cancel, turn the ignition to ACC or IGNITION. Press the warning triangle above the start switch.