Start
See Figure 1. The start switch is on the right handlebar control module. Refer to Table 1.
  1. Switch the OFF/RUN switch to the RUN position. Shift the transmission to neutral. The neutral (green) indicator illuminates. See Operation → Starting the Engine.
  2. Turn the ignition switch to IGNITION. Press the start switch to operate the starter motor.
    3. NOTE
    • When the starter is activated, the headlamp is momentarily turned off to reduce battery load.
    • If the engine does not start, the starter motor runs for 5 seconds and then stops. Release the start switch. Press the start switch to try again. After several unsuccessful attempts to start the engine, see a Harley-Davidson dealer.
Engine Off
See Figure 1. Switch the OFF/RUN switch to the OFF position to shut off the engine. Refer to Table 1.
After turning off the engine. Turn the ignition switch to OFF to disconnect the electric power.
Engine Run
See Figure 1. Push the engine START switch to enable engine start and run. The engine OFF/RUN switch must be in the RUN position to start or operate the engine. Refer to Table 1.
1Off/Run
2Front brake lever adjustment
3Front brake lever
4Throttle twist grip
5Start
6Lamp switch
Figure 1. Right Hand Control Module
Table 1. Right Hand Control Switches
SWITCH
NAME
FUNCTION
Start
Press the switch to start the engine.
Off
Press the switch to the off position to stop the engine or to prevent the engine from starting.
Run
Press the switch to the run position to allow the engine to run.