Regular Service Intervals

Service must be performed at specified intervals to keep your Harley-Davidson motorcycle operating at peak performance. Refer to Service Intervals for table.

Refer to Service Actions for service action definitions used in the service interval table.

NOTE

The use of parts and service procedures other than Harley-Davidson approved parts and service procedures may void the limited warranty. Any alterations to the emission system components, such as the intake and exhaust system, may be in violation of motor vehicle laws.
Some countries, such as Brazil, may require all regular maintenance or additional annual (or semi-annual) regular maintenance steps to be performed to keep your limited warranty in effect and/or comply with vehicle regulations. Check with your authorized Harley-Davidson dealer as well as the motorcycle regulations in your country.
Whenever a vehicle is in for maintenance:
1. always check for and complete recalls and open product programs.
2. always verify that the latest calibration is installed.
After completing the final service interval, repeat the service schedule starting at the 8000 km (5000 mi) interval.

Service Intervals

COMPONENT	1600KM 1000MI	8000KM 5000MI	16000KM 10000MI	24000KM 15000MI	32000KM 20000MI	40000KM 25000MI	48000KM 30000MI	56000KM 35000MI	64000KM 40000MI	72000KM 45000MI	80000KM 50000MI
Service Intervals
Electrical equipment and switches Inspect
Front tire pressure and tread¹ Check
Front wheel spoke tightness (if equipped) ^2,4,3 Check
Front brake fluid level⁷ Inspect
Front brake fluid moisture content ^1,2 Check
Steering head bearings² Adjust
Steering head bearings² Lubricate
Windshield bushings (if applicable) Inspect
Upper and lower switch housing screw torque^1,2,5 Tighten
Clutch lever handlebar clamp screw torque^1,2,5 Tighten
Master cylinder handlebar clamp screw torque^1,2,5 Tighten
Front brake handlebar clamp screw torque^1,2,5 Tighten
Air cleaner filter³ Inspect
Engine oil and filter^1,3 Replace
Oil cooler Clean
Primary chaincase lubricant^3,2 Replace
Transmission lubricant^3,2 Replace
Oil and brake lines^1,2,6 Inspect
Fuel lines and fittings^1,2,6 Inspect
Rear brake fluid level⁷ Inspect
Rear brake fluid moisture content^1,2 Check
Brake systems² Replace	Flush brake systems and replace DOT 4 hydraulic brake fluid every two years or sooner if moisture content is 3 percent or greater.
Brake pads and discs Inspect
Front axle nut torque^1,2,5 Tighten
Jiffy stand^2,3 Lubricate
Clutch system^2,3 Adjust
Brake and clutch controls^2,8 Lubricate
Rear wheel spoke tightness (if equipped) ^2,3,4 Check
Rear tire pressure and tread¹ Check
Drive belt and sprockets² Inspect
Drive belt² Adjust
Rear axle nut torque^1,2,5 Tighten
Exhaust system, fasteners and shields^1,3 Inspect
12 volt battery¹ Check	Check battery, terminal torque and clean connections annually. Lubricate terminals with ELECTRICAL CONTACT LUBRICANT.
Spark plugs Replace	Replace spark plugs every two years or every 30,000 mi (48,000 km), whichever comes first.
Front forks^2,3 Rebuild
Fuel filter^2,3 Replace	Replace fuel filter element every 100,000 mi (161,000 km).
Component and system functions Road Test
NOTES
1. Perform annually or at specified intervals, whichever comes first.
2. Should be performed by an authorized Harley-Davidson dealer, unless you have the proper tools, service data and are mechanically qualified.
3. Perform maintenance more frequently in severe riding conditions. This includes extreme temperatures, dusty environments, mountainous or rough roads, long storage conditions, short runs, heavy stop/go traffic or poor fuel quality.
4. Perform spoke tension check at 1,000 mi (2,000 km), 5,000 mi (8,000 km), 20,000 mi (32,000 km) services and every 15,000 mi (24,000 km) interval thereafter. Not all vehicles have spoked wheels. Consult appropriate topic in the service manual.
5. For torque instructions, see Shop Practices in the service manual.
6. Check for leaks, contact or abrasion.
7. Brake fluid level drops as brake pads wear.
8. Use HARLEY LUBE.

1600KM 1000MI	8000KM 5000MI	16000KM 10000MI	24000KM 15000MI	32000KM 20000MI	40000KM 25000MI	48000KM 30000MI	56000KM 35000MI	64000KM 40000MI	72000KM 45000MI	80000KM 50000MI

Service Intervals

Electrical equipment and switches

Inspect

Front tire pressure and tread

Check

Front wheel spoke tightness (if equipped)

Check

Front brake fluid level

Inspect

Front brake fluid moisture content

Check

Steering head bearings

Adjust

Steering head bearings

Lubricate

Windshield bushings (if applicable)

Inspect

Upper and lower switch housing screw torque

Tighten

Clutch lever handlebar clamp screw torque

Tighten

Master cylinder handlebar clamp screw torque

Tighten

Front brake handlebar clamp screw torque

Tighten

Air cleaner filter

Inspect

Engine oil and filter

Replace

Oil cooler

Clean

Primary chaincase lubricant

Replace

Transmission lubricant

Replace

Oil and brake lines

Inspect

Fuel lines and fittings

Inspect

Rear brake fluid level

Inspect

Rear brake fluid moisture content

Check

Brake systems

Replace

Brake pads and discs

Inspect

Front axle nut torque

Tighten

Jiffy stand

Lubricate

Clutch system

Adjust

Brake and clutch controls

Lubricate

Rear wheel spoke tightness (if equipped)

Check

Rear tire pressure and tread

Check

Drive belt and sprockets

Inspect

Drive belt

Adjust

Rear axle nut torque

Tighten

Exhaust system, fasteners and shields

Inspect

12 volt battery

Check

Spark plugs

Replace

Front forks

Rebuild

Fuel filter

Replace

Component and system functions

Road Test























Flush brake systems and replace DOT 4 hydraulic brake fluid every two years or sooner if moisture content is 3 percent or greater.











Check battery, terminal torque and clean connections annually. Lubricate terminals with ELECTRICAL CONTACT LUBRICANT.
Replace spark plugs every two years or every 30,000 mi (48,000 km), whichever comes first.

Replace fuel filter element every 100,000 mi (161,000 km).

Service Actions

Table 1. Service Action Definitions

ACTION	DEFINITION
Inspect	Carefully examine component for excess wear, abnormality, contact, or leaks.
Check	Verify the component is within the owner’s manual or service manual service limits. Adjust or repair as necessary.
Lubricate	Lubricate the component as specified in the owner’s or service manual with Harley-Davidson approved product.
Replace	Replace the component at the specified intervals.
Clean	Clean the component as specified in the owner’s or service manual.
Rebuild	Rebuild the component according to the procedures in the service manual.

Maintenance Records

Maintain a record of this service to keep your new motorcycle limited warranty in force. Refer to Table 2.

Table 2. Owner's Maintenance Records

SERVICE MILE INTERVAL	DATE	DEALER NUMBER	TECHNICIAN NAME	TECHNICIAN SIGNATURE
1,600 km (1,000 mi)
8,000 km (5,000 mi)
16,000 km (10,000 mi)
24,000 km (15,000 mi)
32,000 km (20,000 mi)
40,000 km (25,000 mi)
48,000 km (30,000 mi)
56,000 km (35,000 mi)
64,000 km (40,000 mi)
72,000 km (45,000 mi)
80,000 km (50,000 mi)