Checking Coolant Level in Coolant Bottle
| 1. | Open the seat. | |
| 2. | VRSCF: Remove front side covers. See Maintenance and Lubrication → Front Side Covers: VRSCF Model. | |
| 3. | See Figure 1. Remove the air box cover by turning the bailhead fastener 1/4 turn counterclockwise. Pull the air box cover away from the front locating holes. | |
 WARNINGDo not loosen or remove pressure cap when cooling system is hot. The cooling system is under pressure and hot coolant and steam can escape from pressure cap, which could cause severe burns. Allow motorcycle to cool before servicing the cooling system. (00091c) | ||
| 4. | See Figure 2. Check coolant level in coolant bottle with coolant cold and motorcycle on jiffy stand. | |
| 5. | If level is below "COLD FULL" line on tank, remove cap from coolant bottle by using pull tab and add GENUINE HARLEY-DAVIDSON EXTENDED LIFE ANTIFREEZE AND COOLANT until fluid level reaches the "COLD FULL" line. NOTE GENUINE HARLEY-DAVIDSON EXTENDED LIFE ANTIFREEZE AND COOLANT is pre-diluted and ready to use full-strength. Do NOT add water. | |
| 6. | Replace the cap on the coolant bottle. | |
| 7. | Install the air box cover. Secure the cover by turning the bailhead fastener 1/4 turn clockwise. | |
| 8. | VRSCF: Install front side covers. See Maintenance and Lubrication → Front Side Covers: VRSCF Model. NOTE If the coolant bottle is empty when the engine is cold, it is possible that air has been drawn into the cooling system. Fill system with coolant and purge any trapped air. See an authorized Harley-Davidson dealer for service. |
NOTICE
Clean the inlet surface of the radiator regularly. Leaves and other debris can collect on the radiator surface and degrade radiator performance which could lead to overheating and motorcycle damage. (00197d)
| 1 | Air box cover |
| 2 | Bailhead fastener |
Figure 1. Air Box Cover
| 1 | Cold full line |
| 2 | Cap |
Figure 2. Coolant Bottle