General

NOTICE

The engine should be allowed to run slowly for 15-30 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00563b)

Rolling the throttle before starting the motorcycle is unnecessary.

Starting

WARNING

Shift transmission to neutral before starting engine to prevent accidental movement, which could result in death or serious injury. (00044a)

1.	NOTE The check engine lamp will light when the ignition is turned on. You will hear the fuel pump run for a short time as it pressurizes the fuel system. See Figure 1. With security fob present, push the off/run switch to on. Do not roll the throttle.
2.	NOTE Starter will not operate if fork lock switch is not in unlocked position. Rotate fork lock switch fully into the unlocked position.
3.	Apply the brake to prevent movement of the motorcycle.
4.	Squeeze the clutch lever in against the handgrip. Shift transmission to neutral.
5.	NOTE To allow enhanced lubrication of the engine before startup, the engine will crank a number of turns before starting. Press the starter button to start the motorcycle.
6.	When the engine has started, you can operate your motorcycle as you normally would after releasing the parking brake. See Before Riding → Parking Brake.

NOTE

The ABS indicator lamp will remain on until vehicle is moving approximately 5 km/h (3 mph).

1	Engine off/run switch
2	Engine start switch

Figure 1. Right Handlebar Controls (typical)