Removal
- Remove two screws to release tail lamp assembly from chrome base.
- See Figure 1. Disconnect tail lamp connector (3).
- Rotate bulb socket (4) 1/4 turn counterclockwise and remove from tail lamp assembly. Pull bulb from socket.
Installation
| 1. | Coat base of new bulb with ELECTRICAL CONTACT LUBRICANT. Install new bulb in socket. | |
| 2. | Insert socket (4) into tail lamp assembly and rotate 1/4 turn clockwise. | |
| 3. | See Figure 1. Connect tail lamp connector (3). | |
| 4. | Place tail lamp into position against chrome base. NOTE Over tightening screws can crack the lens. | |
| 5. | Install two screws and tighten to 2.3–2.7 N·m (20–24 in-lbs). | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 6. | Test tail lamp operation. |
| 1 | Lens |
| 2 | Base |
| 3 | 4-pin multilock connector |
| 4 | Bulb socket |
Figure 1. Tail Lamp Assembly