General
NOTICE
The engine should be allowed to run slowly for 15-30 seconds. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Failure to comply can result in engine damage. (00563b)
Do not roll the throttle before starting. Rolling the throttle before starting the motorcycle is unnecessary.
Starting
| 1. | Turn ignition/headlamp key switch to IGNITION position. Do not roll the throttle. | |
 WARNINGShift transmission to neutral before starting engine to prevent accidental movement, which could result in death or serious injury. (00044a) | ||
| 2. | Shift transmission to neutral. | |
| 3. | See Figure 1. Turn the off/run switch to RUN position. NOTE The engine lamp will light for approximately 4 seconds and you will hear the fuel pump operating for approximately 2 seconds as it fills the fuel lines with gasoline. | |
| 4. | Squeeze the clutch lever in against the handgrip. | |
| 5. | Press the starter button to start the motorcycle. | |
| 6. | Release the parking brake before riding the motorcycle. See Controls and Indicators → Parking Brake. |
NOTE
If it is necessary to start the motorcycle with the transmission in gear (green neutral lamp off), the clutch interlock circuitry requires the clutch be disengaged by pulling the clutch lever in against the left handgrip. The brake should be applied to prevent movement of the motorcycle.
| 1 | Engine off/run switch |
| 2 | Engine start switch |
Figure 1. Right Handlebar Controls