NOTE
HDI models have LED headlamps. LED lamps contain no replacement bulbs. Replace the entire assembly if failure occurs.
Removal
  1. See Figure 1. Remove screw (1). Remove trim ring (2) from lamp housing.
  2. Disconnect headlamp connector.
  3. Remove headlamp bulb assembly and nesting ring.
Installation
1. See Figure 1. Place nesting ring (4) on back of new bulb (3) with the index tab facing away from bulb.
2. Install bulb assembly.
3. Mate connector to bulb.
4. Engage index tab of nesting ring with slot at bottom of lamp housing.
5. Engage index tabs on bulb assembly with slots in nesting ring.
6. Install trim ring on lamp housing with screw centered at bottom. Tighten to 1–1.6 N·m (9–14 in-lbs).
7. Check headlamp alignment. See Maintenance and Lubrication → Headlamp Alignment: HDI.
1Screw
2Ring
3Headlamp bulb
4Nesting ring
Figure 1. Headlamp Assembly