NOTE
Models with LED lamps do not contain replacement bulbs. Replace the LED assembly.
| 1. | See Figure 1. Insert a coin or the blade of a small screwdriver into the notch at the bottom of the lens cap. Carefully twist until the lens cap pops out of the lamp housing. | |
| 2. | Push bulb in and rotate counterclockwise. Pull bulb from socket. | |
| 3. | Inspect condition of electrical contacts in socket. If necessary, clean with a small wire brush and electrical contact cleaner. | |
| 4. | Apply ELECTRICAL CONTACT LUBRICANT to contacts in socket and at bottom of new bulb. | |
| 5. | Align pins on new bulb with pin guides in bulb socket. Push bulb in and turn clockwise to lock in place. | |
| 6. | Snap lens cap onto the lamp housing with notch at bottom. | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 7. | Check operation of all lamps. |
Figure 1. Lens Cap Notch