| 1. | See Figure 1. Turn ignition switch OFF. | |
| 2. | Remove two screws and lens from base. NOTE Disconnect 4-Pin multilock connector from circuit board to simplify bulb removal. | |
| 3. | Remove bulb assembly from lens. Remove bulb. | |
| 4. | Coat base of new bulb with ELECTRICAL CONTACT LUBRICANT. Install new bulb. | |
| 5. | Install bulb assembly to lens. | |
| 6. | If removed, connect 4-pin multilock connector to circuit board. | |
| 7. | Install lens to base with two screws. Tighten to 2.3–2.7 N·m (20–24 in-lbs). | |
 WARNINGBe sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a) | ||
| 8. | Turn ignition on and test for proper tail lamp operation. |
| 1 | Lens |
| 2 | Base |
| 3 | 4-pin multilock connector |
| 4 | Bulb assembly |
Figure 1. Tail Lamp Assembly